GAUER 9H-10 EDGE DEBURRING MACHINE
This 9H-10 mechanical bar edging system has been designed to cover a wide
gamut of requirements. It can produce edge finished bar from sheared plate
eliminating the necessity of stocking hundreds of different sizes, ranging
up to ten inches wide.
SPECIFICATIONS:
-
Model: 9H-10
-
Width Range: 1/2 inch to 10 inches
-
Thickness Range:
20ga. (.0344") to 3/16"
-
Material: Cold or hot rolled steel, stainless
steel, aluminum, copper, and brass
-
Speed: Up to 125 ft/min (variable speed)
-
Electrical: 230/460 Volts, 3 phase, 60 Hertz
ENGINEERED FOR RUGGED DUTY
The advanced design coupled with the use of quality components and
stringent controls during manufacture make the 9H-10 a very durable,
extremely efficient system for in-plant edging of metal strip. Edging
capability along with the decambering and detwisting performance of this
equipment can provide a flexibility of production that will result in
reduced costs. These savings can be realized by eliminating inventories of
pre-edged material and possible delays in production runs caused by outside
suppliers.
The 9H-10 can be ordered equipped with a variable speed drive and loop
control that makes synchronization with other line equipment extremely
easy. The finished edge may be varied from a deburred safe edge within the
complete thickness range, to a rounded corner edge on 3/16" material.
Camber and twist control are achieved by simple adjustments.
OPTIONAL EQUIPMENT
Override Clutch: Permits stock to be pulled thru machine by other
equipment.
Variable Speed: 0 - 125 ft/min Electrical requirement 230 v. single
phase, 60 Hz. (SCR Drive System)
Variable Speed with Loop Control: SCR Drive System with dancer arm limit
switch control.