GAUER 6H-10 EDGE DEBURRING MACHINE
Provides many of the same capabilities as the 9H-10, but for lighter duty
operations. Can also be equipped for coil line operations. This machine is
recommended for coil line applications where width adjustment is from a
constant back edge.
SPECIFICATIONS:
-
Model: 6H-10
-
Width Range: 5/8" to 10"
-
Thickness Range:
20ga. (.0344") to 11ga. (.125")
-
Material: Cold or hot rolled steel, stainless
steel, aluminum, copper, and brass
-
Speed: Up to 125 ft/min (variable speed)
-
Electrical: 230/460 Volts, 3 phase, 60 Hertz
PRODUCTION LINE ENGINEERED
The 6H-10 has been engineered to fit into, and/or compliment production
line requirements, eliminating extra costs and possible delays caused by
ordering previously round edged or deburred material. Additionally, by round
edging or deburring in your plant (on your own equipment) there is no need
to carry inventories of pre-edged material. In line with the obvious
advantages of in-plant edging, the 6H-10 provides excellent decambering and
detwisting capabilities on sheared or coil stock. This machine can also be
equipped with an override clutch or variable speed and loop control,
permitting synchronization with other components in coil line operations.
The 6H-10 machine satisfies that market segment occupied by the company
who needs a quality machine that can edge strip or blanks, requires the
ability to decamber and detwist and/or can use an edging machine in coil
line operations at minimum labor cost.
OPTIONAL EQUIPMENT
Override Clutch: For coil line, pull thru operation permitting material
to be pulled through the machine by an outside power source at production
cycle speed.
Variable Speed w/ Loop: SCR DC Drive Motor and Loop Control Arm, speed
0-125 ft/min.